Aviation obstruction light physical wiring diagram

There are two mainstream wiring methods for aviation obstruction lights currently on the market, corresponding to two types of aviation obstruction lights: intelligent and control.

There is only one power cord at the bottom of the intelligent obstruction light, and the synchronization signal is collected through the power cord, and the wiring is relatively simple. This is a three-strand cable, red (positive), black or blue (negative) and yellow (ground). As shown below:

The control type obstruction light has two sets of wiring: power cord + synchronization line. The power cord is the same as the intelligent type, it is a three-stranded line, and there is a single-stranded synchronization line used to connect the lamps through the built-in program in the control box. , Can realize the function of synchronous flashing, sequential flashing and so on. The wiring is relatively simple because it has more synchronization lines than the intelligent type. As shown below: